• Aircraft trajectory optimization. Analysis of uncertainty in aircraft trajectories.
• Air traffic management.
• Aircraft gas turbines diagnostics: evaluation of engine/turbomachinery degradation through on-site data analysis and system modelling.
• Analysis and Design of aeronautical structures.
• Avionics, navigation systems, digital communications, software tools for data loading of software on board.
• Communications Electronics.
• Control system engineering.
• Design and control of UAVs.
• Development of automatic flight control and navigation control strategies
• Development of new propulsion cycles and engine performance evaluation.
• Dynamic of Mechanical Systems
• Electromagnetic compatibility.
• Embedded systems
• Failure criteria of composites.
• Fatigue and Fracture Mechanics.
• Fluid Mechanics
• Fracture Mechanics applied to composites
• Mechanical Behaviour of Materials.
• MEMS Technologies
• Modelling of damage in composites
• Power Electronics.
• Space vehicle flight dynamics and control strategies.
• Stress analysis and failure prediction in adhesive joints with composite materials.
• Testing of aeronautical structures.
• Testing of metallic and composite materials.

• Wind Tunnel
• Aerospace Teaching Laboratory.
• Experimental modal analysis equipment.
• 20 kN Shaking table with frequencies between 5 Hz and 2 kHz
• 10 kN Resonant fatigue testing machine (50 to 200 Hz)
• Several uniaxial servohidraulic dynamic testing machines (15 kN, 50 kN, 100 kN, 250 kN) (0 to 30 Hz)
• Two biaxial servohidraulic dynamic testing machines (25 kN, 100 kN) (0 to 30 Hz).
• 3D continuos fibre (carbo/glass/kevlar) reinforced composite printer.
• Composites repair system (Hot bonder).
• 2 multiphase electrical drives workstations
• 2 electrical vehicles
• 5 quadcopters.
• Power electronics laboratory.
• Ad hoc network with 30 nodes
• Anechoic chamber and EMC instrumentation
• Two turboshafts test bench. These belong to the Spanish Army and through an agreement with Seville University are used for research activities.
• MEMS Clean room.
• Universal testing machines.
• Ovens and furnaces.
• Climatic chambers.
• Autoclave.
• Clean room for hand lay up of composites.
• Salt spray chamber.
• Optical microscopy.
• Photoelasticity and extensometry
• Shaker

• Full professors: 19
• Associate professors: 31
• Assistant professors: 27
• Postdoc: 11
• PhD candidates: 45

For exchange possibilities, click here

For Ph.D. positions, click here